RE-INJECTO™ LB

Blue, plastic injection hose with circular profile with an outside diameter of approx. 11mm and an inner transport duct of approx. 5mm. The injection tube has micro slits every 12 to 14mm to allow the injection material to exit the tube into the joint. The slits open with the injection pressure to allow injection grout to exit the tube and fill the joint. After injection, the slits will close again due to the reset force of the plastic closing the tube. The tube can be rinsed with water using a pressure of 0.5 bars.

Easy to re-inject using OMNITEK™ Inject or GELACRYL™ resins.
Can be injected but not re-injected with polyurethane or epoxy resins.
Simple installation using the twinbox.
Does not twist when unrolled from the coil.
Allows injections of pure resin at lengths up to 10m.
Allows injections of micro fine cements at lengths up to 6m.
RE-INJECTO™ LB can be adapted on site to the exact length of the construction joint.
Easy to handle, no special equipment required.
The system allows injection under low pressure.
Permanent seal after injection.
No leak, no injection necessary.
Can be bent without risk of closing up the tube.
The profile prevents collapse of the tube through the weight of the concrete.
The Re-Injecto LB hose can withstand concrete pressures of up to 20m.

Sealing cold and construction joints, pipe penetrations, joints between diaphragm walls and slabs through post-injection with Omnitek Inject micro-fine cement or Gelacryl resin where consecutive re-injections are needed.